Compaq 470007-802 Deskpro EN Series of Personal Computers - Slim Desktop Model - Page 56

-Inch Drives, At the same time, push the drive toward the back of the computer

Get Compaq 470007-802 - Deskpro EN - 256 MB RAM PDF manuals and user guides View all Compaq 470007-802 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 56 highlights

4.13 5.25-Inch Drives CAUTION: When the computer is plugged into an AC power source, there is always voltage applied to the system board. You must disconnect the power cord from the power source before opening the computer to prevent system board or component damage. 1. Prepare the computer for disassembly (Section 4.2). 2. Remove the access panel (Section 4.6). 3. Disconnect the drive power cable, signal cable, and audio connector from the drive, if applicable. 4. Press the drive release latch (labeled with an arrow) forward 1. 5. At the same time, push the drive toward the back of the computer 2, then lift it out of the drive cage 3. To install a drive, reverse the removal procedure. Compaq Deskpro EN Series of Personal Computers 4-23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
Compaq Deskpro EN Series of Personal Computers
4-23
4.13
5.25-Inch Drives
CAUTION:
When the computer is plugged into an AC power source, there is always voltage
applied to the system board. You must disconnect the power cord from the power source before
opening the computer to prevent system board or component damage.
1.
Prepare the computer for disassembly (Section 4.2).
2.
Remove the access panel (Section 4.6).
3.
Disconnect the drive power cable, signal cable, and audio connector from the drive, if
applicable.
4.
Press the drive release latch (labeled with an arrow) forward
1
.
5.
At the same time, push the drive toward the back of the computer
2
, then lift it out of
the drive cage
3
.
To install a drive, reverse the removal procedure.