Compaq 470007-802 Deskpro EN Series of Personal Computers - Slim Desktop Model - Page 66

Speaker, Remove the four screws that connect the speaker to the chassis.

Get Compaq 470007-802 - Deskpro EN - 256 MB RAM PDF manuals and user guides View all Compaq 470007-802 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 66 highlights

4.21 Speaker 1. Prepare the computer for disassembly (Section 4.2). CAUTION: When the computer is plugged into an AC power source, there is always voltage applied to the system board. You must disconnect the power cord from the power source before opening the computer to prevent system board or component damage. 2. Remove the access panel (Section 4.6). 3. Disconnect the speaker wire from the P6 connector located on the corner of the system board near the battery 1. 4. Remove the four screws that connect the speaker to the chassis. 5. Remove the speaker. To install the speaker, reverse the removal procedure. Compaq Deskpro EN Series of Personal Computers 4-33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
Compaq Deskpro EN Series of Personal Computers
4-33
4.21
Speaker
1.
Prepare the computer for disassembly (Section 4.2).
CAUTION:
When the computer is plugged into an AC power source, there is always voltage
applied to the system board. You must disconnect the power cord from the power source before
opening the computer to prevent system board or component damage.
2.
Remove the access panel (Section 4.6).
3.
Disconnect the speaker wire from the P6 connector located on the corner of the system
board near the battery
1
.
4.
Remove the four screws that connect the speaker to the chassis.
5.
Remove the speaker.
To install the speaker, reverse the removal procedure.