Compaq 470013-444 Deskpro EX Series of Personal Computers Maintenance&Serv - Page 35
Removing the Diskette Drive
UPC - 720591804381
View all Compaq 470013-444 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
4.7.3 Removing the Diskette Drive 1. Prepare the computer for disassembly (Section 4.2). WARNING: Power is continuous to the system board and power supply even when the power switch is turned off. To prevent damage to the unit, disconnect the power cord from the power source or the unit before beginning disassembly procedures. 2. Remove the computer cover (Section 4.3). 3. Remove the side-mounted hard drive (Section 4.7.1). 4. Disconnect the data cable and the drive power cable. 5. Facing the drive, remove the retaining screw on the right side of the drive that secures the drive in the bay 1. 6. While pushing the release latch on the bottom of the bay down 2, pull the diskette drive out of the bay 3. To install a diskette drive, reverse the above procedure. ✎ When installing a new diskette drive, be sure to exchange the guide screws from the old drive. ✎ When replacing the drive, use the existing screws. Metric screws (M3) have a black finish while U.S. screws (#6-32) have a silver finish. CAUTION: When servicing the computer, ensure that cables are placed in their proper locations during the reassembly process. Improper cable placement can damage the computer. CAUTION: Use only 3/16-inch or 5-mm long screws as guide screws. Longer screws can damage the internal components of the drive. Compaq Deskpro EX Series of Personal Computers 4-11