Compaq Armada V300 Compaq Armada E500 and Armada V300 Maintenance and Service - Page 41
Table 2-1, Warning Messages, Message, Description, Recommended Action - ram
View all Compaq Armada V300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
If you receive one of the error messages listed below, follow the recommended action. Table 2-1 Warning Messages Message Description Recommended Action CMOS checksum invalid, run SCU CMOS RAM information has been corrupted. Run Computer Setup (Section 2.5) to reinitialize CMOS-RAM. CMOS failure, run SCU CMOS RAM has Run Computer Setup lost power. (Section 2.5) to reinitialize CMOS-RAM. Diskette controller error The diskette drive controller failed to respond to the recalibrate command. If there is no diskette drive in the system, run Computer Setup (Section 2.5) to properly configure the CMOS-RAM to show no diskette drive present. If the problem persists, or if a diskette drive is present, complete these steps until the problems are solved: 1. Check diskette drive connections. 2. Replace diskette drive. 3. Replace system board. Diskette track 0 failed The diskette drive cannot read track 0 of the diskette in the drive. Try another diskette. If the problem persists, you may need to replace the diskette drive. Hard disk controller error The hard drive Check the drive parameters. controller failed Turn off the system and to respond to the check all related reset command. connections. Keyboard controller failure The keyboard failed the selftest command. Replace the system board. Continued Troubleshooting 2-5