Compaq Evo n610c Compaq Evo Notebook N600c, N610c, N610v and N620c Notebook PC - Page 161
Heat sink Top cover
View all Compaq Evo n610c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Removal and Replacement Procedures g. Top cover (Section 5.12) h. System board (Section 5.13) i. Heat sink (Section 5.15) 2. Turn the system board bottom side up with the rear panel facing you. 3. Insert the tip of a flat-blade screwdriver into the slot on the processor locking screw. 4. Turn the screwdriver counterclockwise 1 to release the processor (Figure 5-34). 5. Remove the processor from the socket on the system board 2. ✎ When installing the processor, make sure the gold triangle 3 is in the lower right corner. Figure 5-34. Removing the Processor Reverse the preceding procedure to replace the processor. Maintenance and Service Guide 5-51
Removal and Replacement Procedures
Maintenance and Service Guide
5–51
g.
Top cover (Section 5.12)
h.
System board (Section 5.13)
i.
Heat sink (Section 5.15)
2. Turn the system board bottom side up with the rear panel
facing you.
3. Insert the tip of a flat-blade screwdriver into the slot on the
processor locking screw.
4. Turn the screwdriver counterclockwise
1
to release the
processor (Figure 5-34).
5. Remove the processor from the socket on the system
board
2
.
✎
When installing the processor, make sure the gold triangle
3
is in
the lower right corner.
Figure 5-34. Removing the Processor
Reverse the preceding procedure to replace the processor.