Compaq d530 HP Compaq Business Desktop d500 Service Reference Guide, 5th Editi - Page 137
When replacing the hard drive, transfer the four screws from the old drive to the new one.
View all Compaq d530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Removal and Replacement Procedures- Small Form Factor (SFF) Chassis 7. Press and hold the drive release latch 1. 8. Slide the drive to the right of the bay 2, then pull the drive from the bay 3. To replace the hard drive, reverse the above procedure. Make sure you position all cable correctly before returning the drive cage to its original position (Section 7.10.2, "Cable Routing"). ✎ When replacing the hard drive, transfer the four screws from the old drive to the new one. The screws take the place of drive rails. You will need a Torx T-15 screwdriver to remove and re-install the guide screws. Service Reference Guide, d500 336492-005 7-23
Service Reference Guide, d500
336492-005
7–23
Removal and Replacement Procedures— Small Form Factor (SFF) Chassis
7. Press and hold the drive release latch
1
.
8. Slide the drive to the right of the bay
2
, then pull the drive from the bay
3
.
To replace the hard drive, reverse the above procedure.
Make sure you position all cable correctly before returning the drive cage to its original position
(
Section 7.10.2, “Cable Routing”
).
✎
When replacing the hard drive, transfer the four screws from the old drive to the new one. The
screws take the place of drive rails. You will need a Torx T-15 screwdriver to remove and
re-install the guide screws.