Cub Cadet RZT L 34 Operation Manual - Page 12

Air Filter Service

Page 12 highlights

Add Oil 1. Unscrew the thumb screws and remove the air filter cover. IMPORTANT: Be sure to check engine on a level surface with the See Figure 6-4. engine stopped. 1. Wipe around dipstick cap and tube with a clean cloth to remove any debris. See Figure 6-3. Air Filter Cover Thumb Screw Figure 6-3 2. Remove dipstick and wipe clean with a cloth. 3. Pour oil into the dipstick tube. Do not over fill. With an oil filter change the high level amount of oil for this engine is 1700 ml (57.48 fl-oz.). 4. Install dipstick and turn to locked position before starting engine. 5. Start engine. Allow to run for a few seconds and then shut down the engine. 6. Check the oil level. See Checking Oil Level section. Air Filter Service Paper filters cannot be cleaned and should be replaced every 100 operating hours; more often if used in extremely dusty conditions. WARNING: Never use gasoline or low flash point solvents for cleaning the air filter element. A fire or explosion could result. IMPORTANT: Never run the engine without the air filter. Rapid engine wear will result. Figure 6-4 a. Remove thumb screw. b. Pull up and remove air filter and base seal. See Figure 6-5. A B Figure 6-5 12 Section 6 - Maintenance

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

12
S
ECTION
6 — M
AINTENANCE
1.
Unscrew the thumb screws and remove the air filter cover.
See Figure 6-4.
Air Filter
Cover
Thumb
Screw
Figure 6-4
a.
Remove thumb screw.
b.
Pull up and remove air filter and base seal. See
Figure 6-5.
A
B
Figure 6-5
Add Oil
IMPORTANT:
Be sure to check engine on a level surface with the
engine stopped.
1.
Wipe around dipstick cap and tube with a clean cloth to
remove any debris. See Figure 6-3.
Figure 6-3
2.
Remove dipstick and wipe clean with a cloth.
3.
Pour oil into the dipstick tube.
Do not over fill.
With an oil
filter change the high level amount of oil for this engine is
1700 ml (57.48 fl-oz.).
4.
Install dipstick and turn to locked position before starting
engine.
5.
Start engine. Allow to run for a few seconds and then shut
down the engine.
6.
Check the oil level. See Checking Oil Level section.
Air Filter Service
Paper filters cannot be cleaned and should be replaced every
100 operating hours; more often if used in extremely dusty
conditions.
WARNING:
Never use gasoline or low flash point
solvents for cleaning the air filter element. A fire or
explosion could result.
IMPORTANT:
Never run the engine without the air filter. Rapid
engine wear will result.