Cub Cadet SC 700 e Operation Manual - Page 10
Attaching Side Discharge Chute or Side - battery
View all Cub Cadet SC 700 e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
ASSEMBLY Attaching the Grass Catcher (If Equipped) 1. Perform the following to assemble the grass catcher (Figure 12). NOTE: Before assembling the grass catcher, ensure the grass bag is turned right side out, with the warning label showing on the outside. a. Place bag over frame so that its black plastic side is at the bottom. b. Slip plastic channels (a) of grass bag over the frame (b). b Attaching Side Discharge Chute or Side Discharge Blower (If Equipped) The mower is shipped as a mulcher. To convert to side discharge or side discharge blower, ensure the grass catcher is removed, the rear mulch plug is installed (if equipped) and the rear discharge door is closed. 1. Lift the mulch plug (Figure 14). 2. Slide the two hooks of the side discharge chute (a) or side discharge blower (b) under the mulch plug hinge pin. Lower the mulch plug. IMPORTANT: Do not remove side mulch plug at any time. 1 1 a a b 2 2 Figure 12 2. Follow steps below to attach grass catcher (Figure 13): a. Lift rear discharge door (a). b. Remove the rear mulch plug (b) (if equipped). c. Place grass catcher into the slots in the handle brackets (c). Lower the discharge door so that it rests on the grass catcher. NOTE: To remove grass catcher, lift rear discharge door on the mower. Lift grass catcher up and off the slots in the handle brackets. Reinstall the rear mulch plug (if equipped). Release rear discharge door to allow it to close rear opening of mower. a b Figure 14 NOTE: Some side discharge chutes include a clip to secure the discharge chute to the handle. If equipped, the side discharge chute can be secured to the handle when not in use (Figure 15). Figure 15 Electric Start Set-Up (If Equipped) NOTE: Remove cable tie (a) from around battery box. Cable tie is used for shipping only (Figure 16). a c c Figure 13 a 10 Figure 16