Cub Cadet Z-Force SX 60 Operation Manual - Page 10

Install Operator's Seat To install the seat proceed as follows: NOTE: The seat is shipped with the seat switch and seat pan attached. 1. Cut any straps securing the seat assembly to the tractor. Remove any packing material. NOTE: Be careful not to cut the wiring harness connecting the seat and the seat switch. 2. Remove the two shoulder screws and flange lock nuts in the seat bracket as shown in Figure 3-3. Lower Deck Discharge Chute Deflector WARNING! Never operate the mower deck without the chute deflector installed and in the down position. The discharge chute deflector must be installed before operating the mower. To install the chute deflector, proceed as follows: 1. Remove the carriage screws and flange lock nuts installed on the mounting bracket on the deck. See Figure 3-5. Figure 3-5 Figure 3-3 2. With the previously removed hardware, install the chute deflector on the deck as shown in Figure 3-5. 3. Rotate the seat into position and secure the seat into place with the previously removed shoulder screws and flange Adjusting the Seat lock nuts. Be careful not to crimp or damage the wire 1. To adjust the position of the seat, push the seat adjustment harness while installing the seat. See Figure 3-4. lever to the left. See Figure 3-6. 2 1 Figure 3-4 NOTE: Be sure to push the excess wire from the wire harness into the seat box hole before continuing. 10 Section 3 - Assembly & Set-Up Figure 3-6 2. Slide the seat forward or rearward to the desired position; then release the adjustment lever. Make sure seat is locked into position before operating the tractor. See Figure 3-6.