Cub Cadet Z-Force SX 60 Operation Manual - Page 18
Driving The Tractor
View all Cub Cadet Z-Force SX 60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Using Jumper Cables To Start Engine WARNING! Batteries contain sulfuric acid and 2. To travel FORWARD, slowly press the forward drive pedal forward until the desired speed is achieved. See Figure 5-2. produce explosive gasses. Make certain the area is well ventilated, wear gloves and eye protection, and avoid sparks or flames near the battery. If the battery charge is not sufficient to crank the engine, Forward Drive Pedal recharge the battery. If a battery charger is unavailable and the tractor must be started, the aid of a booster battery will be necessary. Connect the booster battery as follows: 1. Connect the end of one cable to the disabled tractor battery's positive terminal; then connect the other end of that cable to the booster battery's positive terminal. 2. Connect one end of the other cable to the booster battery's negative terminal; then connect the other end of that cable to the frame of the disabled tractor, as far from the battery as possible. 3. Start the disabled tractor following the normal starting instructions previously provided; then disconnect the jumper cables in the exact reverse order of their connection. Reverse Drive Pedal 4. Have the tractor's electrical system checked and repaired as soon as possible to eliminate the need for jump starting. Parking Brake/Cruise Control Lever Stopping the Engine Figure 5-2 1. Place the PTO switch in the disengaged position. 3. To stop or slow down the tractor, take your foot off of the 2. Engage the parking brake. 3. Move the throttle to the SLOW position and allow the engine to idle for about one minute. forward or reverse drive pedal . To lock the parking brake, press forward on the brake pedal, then press down on the parking break/cruise control lever and then release the brake pedal . 4. Turn the ignition key to the STOP position and remove the key from the ignition switch. NOTE: Always remove the key from the ignition switch to prevent accidental starting or battery discharge if the equipment is left unattended. 4. To use the cruise control: e. Press down on the forward drive pedal . f. While maintaining the desired speed press down on the parking break/cruise control lever then release 5. Close the fuel shut-off valve. Driving The Tractor WARNING! Avoid sudden starts, excessive speed and sudden stops. 1. Release the parking brake. Move the throttle control lever into the FAST position. the forward drive pedal to activate the cruise control. 7. To release the cruise control, press the brake or the forward drive pedal . NOTE: The forward and reverse drive pedals must not be used when the brake is partially engaged. When the brake is locked the drive belt is disengaged but if the brake is only part way back then the brakes are engaged but so is the drive belt so transmission damage will occur if you push forward or reverse. 8. To travel in reverse, check that the area behind is clear then slowly push down on the reverse drive pedal with the ball of your foot (NOT your heel) until the desired speed is achieved. See Figure 5-2. CAUTION: Do NOT attempt to change the direction of travel when the tractor is in motion. Always bring the tractor to a complete stop before moving the tractor from forward to reverse or vice versa. WARNING! Do not leave the seat of the tractor without first placing the PTO knob in the disengaged (OFF) position and engaging the parking brake. If leaving the tractor unattended, also turn the engine off and remove the ignition key. 18 Section 5- Operation