Cub Cadet Z-Force SX 60 Operation Manual - Page 24

General Battery Information WARNING! • Should battery acid accidentally splatter into the eyes or onto the skin, rinse the affected area immediately with clean cold water. If there is any further discomfort, seek prompt medical attention. • If acid spills on clothing, first dilute it with clean water, then neutralize with a solution of ammonia/ water or baking soda/water. • NEVER connect (or disconnect) battery charger clips to the battery while the charger is turned on, as it can cause sparks. • Keep all sources of ignition (cigarettes, matches, lighters) away from the battery. The gas generated during charging can be combustible. • As a further precaution, only charge the battery in a well ventilated area. • Always shield eyes and protect skin and clothing when working near batteries. • Batteries contain sulfuric acid and may emit explosive gases. Use extreme caution when handling batteries. Keep batteries out of the reach of children. Battery Maintenance • The battery is filled with battery acid and then sealed at the factory. However, even a "maintenance free" battery requires some maintenance to ensure its proper life cycle. • Spray the terminals and exposed wire with a battery terminal sealer, or coat the terminals with a thin coat of grease or petroleum jelly, to protect against corrosion. • Always keep the battery cables and terminals clean and free of corrosion. • Avoid tipping. Even a sealed battery will leak electrolyte when tipped. WARNING! Batteries contain sulfuric acid and may emit explosive gases. Use extreme caution when handling batteries. Keep batteries out of the reach of children. Battery Storage 1. When storing the tractor for extended periods, disconnect the negative battery cable. It is not necessary to remove the battery. 2. All batteries discharge during storage. Keep the exterior of the battery clean, especially the top. A dirty battery will discharge more rapidly. 3. The battery must be stored with a full charge. A discharged battery can freeze sooner than a charged battery. A fully charged battery will store longer in cold temperatures than hot. 4. Recharge the battery before returning to service. Although the tractor may start, the engine charging system may not fully recharge the battery. Using the Transmission Bypass Rods If for any reason the tractor will not drive or you wish to move the tractor, the two hydrostatic transmissions are equipped with a bypass rod that will allow you to manually move the tractor short distances. WARNING! Do not tow the tractor, even with the bypass rod engaged. Serious transmission damage will result from doing so. 1. From the rear of the tractor, just inside the two rear tires, locate the transmission bypass rods. Refer to Figure 6-5. a b Figure 6-5 WARNING! Do not attempt to engage the bypass rods when the engine is running or hot. 2. Engage the transmission bypass rods, one on each side of the tractor, to move the tractor manually without starting it. The transmission bypass rods are located on the rear of the tractor, just inside each rear wheel. Engage the bypass rods by pulling each one out (a) and to the right (b) to lock it into place. See Figure 6-5. NOTE: The tractor will not drive with the bypass rods in the engage position. 3. Disengage the bypass rods by reversing steps a & b after moving the tractor. See Figure 6-5. Hydrostatic Transmission Your zero turn tractor is equipped with dual integrated hydrostatic pumps/transaxles that are sealed and are maintenance-free. However, this model is equipped with a transmission oil expansion reservoir. Under normal operating conditions, the oil level in the expansion reservoir does not need to be checked and no additional oil is needed. If checking the reservoir oil level, proceed as follows: WARNING! Check the oil level ONLY before starting the tractor when the transmission oil is fully cooled. 24 Section 6- Maintenance & Adjustments