D-Link DES-1316 Product Manual - Page 15
Rear Panel - reset
UPC - 790069271700
View all D-Link DES-1316 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Ethernet Ports (Port 9~16): These ports support network speeds of either 10Mbps or 100Mbps, and can operate in half- and full- duplex transfer modes. These ports also support the automatic MDI/MDIX crossover detection function, providing true "plug and play" capability. Just plug-in the network cable to the hub directly and regardless if the end node is a NIC (Network Interface Card) or switch and hub Note: When the port is set to "Forced Mode", Auto MDI/MDIX will be disabled. Rear Panel Reset Button AC Power Connector Figure 4. Rear panel of the Switch AC Power Connector: This is a three-pronged connector that supports the power cord. Plug in the female connector of the provided power cord into this connector, and the male into a power outlet. Supported input voltages range from 100-240V AC at 50-60Hz. Reset: The Reset button is to reset all settings back to the factory defaults. Note: Be sure that you recorded the settings of your device, else all settings will be erased when pressing the "Reset" button. 15