D-Link DES-3224 Product Manual - Page 17
Power
UPC - 790069223334
View all D-Link DES-3224 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
10/100 Auto Negotiation Switch User's Guide Desktop/ Shelf Installation Follow these steps to install the DES-3224 on a desktop or shelf: 1. Place the four rubber pads at the four corners of the DES-3224. 2. Install the DES-3224 on the desktop/shelf where you would like to place it. Rack Installation The DES-3224 can be mounted in an EIA standard size, 19 inch rack. The dimensions of the DES-3224 are 17.4 x 10.4 x 2.48 inches. The DES-3224 can be placed in a wiring closet along with other equipment. Follow these steps to install the DES-3224 on a rack: 1. Attach a mounting bracket to each side of the DES-3224 with the screws provided. 2. Slide the DES-3224 into the rack and use the screws provided to secure the DES-3224 to the rack. 3. Connect the power cord and verify that the DES-3224 is receiving adequate power. Power On The power supply will adjust to the local power source automatically. The DES-3224 may be plugged in without having any or with all LAN segment cables connected. The power plug is located at the rear of the DES-3224. Plug the cable into the wall socket and plug the other end into the DES-3224. There is no on/ off switch. The DES-3224 powers on when you plug the power cord into the three-pronged power connector. When the DES3224 is powered on, the Power Led will light and all ports will auto negotiate the proper speed and duplex mode. Reboot the DES-3224 if there is a problem. Contact D-Link Systems, Inc. for technical support. Check the configuration of the DES-3224 after a power failure but do not reset unless it is necessary. The DES-3224 can be used with power sources in the range 100 to 240 VAC., 50 to 60 Hz. Installing the DES-3224 7