D-Link DGS-3620-52P-SE-LIC Reference Guide - Page 225
PIM Candidate RP Settings
View all D-Link DGS-3620-52P-SE-LIC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 225 highlights
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide Click the Edit button to see the following window. Figure 5-84 PIM Candidate BSR Settings - Edit window The fields that can be configured are described below: Parameter Description Priority Enter a value -1 or from 0 to 255. The default value is -1 which means the BSR state is disabled. PIM Candidate RP Settings The following window is used to set the Parameters for this Switch to become a candidate RP. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM Candidate RP Settings, as shown below: Figure 5-85 PIM Candidate RP Settings window The fields that can be configured are described below: Parameter Candidate RP Hold Time (0-255) Candidate RP Priority (0-255) Description This field is used to set the time Candidate RP (CRP) advertisements are valid on the PIM-SM enabled network. If CRP advertisements are not received by the BSR within this time frame, the CRP is removed from the list of candidates. The user may set a time between 0 and 255 seconds with a default setting of 150 seconds. An entry of 0 will send out one advertisement that states to the BSR that it should be immediately removed from CRP status on the PIM-SM network. Enter a priority value to determine which CRP will become the RP for the distribution tree. This priority value will be included in the router's CRP advertisements. A lower value means a higher priority, yet, if there is a tie for the highest priority, the router having the higher IP address will become the RP. The user may set a priority between 0 and 255 with a default setting of 192. 215