D-Link DGS-3620-52P-SE-LIC Reference Guide - Page 232
PIM for IPv6 Static RP Settings, PIM for IPv6 Neighbor Table
View all D-Link DGS-3620-52P-SE-LIC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide Figure 5-96 PIM for IPv6 Candidate RP Settings window The fields that can be configured are described below: Parameter Description Group Enter the IPv6 group address range served by the RP. Interface Name Enter the interface that will act as the Candidate RP. Interface Name Enter the RP IP interface used. Tick the All check box to select all RP IP interface. Priority (0-255) Enter the RP priority value that will be used in the election process. Interval (1-16383) Enter the Candidate RP advertisement interval in seconds. Click the Add button to add a new entry based on the information entered. Click the Apply button to accept the changes made. Click the Delete button to remove the specific entry. PIM for IPv6 Static RP Settings This window is used to create a static RP. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for IPv6 Static RP Settings, as shown below: Figure 5-97 PIM for IPv6 Static RP Settings window The fields that can be configured are described below: Parameter Description Group Enter the multicast group network address for this static RP. RP Address Enter the IPv6 address to this static RP. Override Dynamic Tick the check box so that the static RP will override any dynamically learned RP. Click the Add button to add a new entry based on the information entered. Click the Delete button to remove the specific entry. PIM for IPv6 Neighbor Table 222