D-Link DI-714P Product Manual - Page 30
Tools> Admin, Authentication, SSID Broadcast, Password, Remote, Management, IP Address - default password
UPC - 790069247057
View all D-Link DI-714P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Using the Configuration Menu Authentication- Select Open system, Shared Key or Both Open System - The DI-714P+ will be visible to all devices on the network. This is the default setting Shared Key - In this mode, in order to access the DI-714P+ on the network, the device must be listed in the MAC Address Control List Both - In this mode, all devices on the network can access the DI-714P+ SSID Broadcast- Enable is the default setting. Choose Enable to broadcast the SSID across the network. All devices on a network must share the same SSID (Service Set Identifier) to establish communication. Choose Disable if you do not wish to broadcast the SSID over the network. Tools> Admin You can change the admin password here. It is recommended that you change the admin password from the default setting.The default password is blank (nothing). PasswordRemote Management- IP AddressPort- To change the admin password, enter in the old password, and enter the new password twice to confirm Remote Management allows the device to be configured through the WAN (Wide Area Network) port from the Internet using a web browser. A username and password is still required to access the browser-based management interface. Internet IP Address of the computer that has access to the DI-714P+. If the IP Address is set to 0.0.0.0, this allows all Internet IP addresses to access the DI-714P+. The port number used to access the DI-714P+. Example:http://x.x.x.x:8080, where x.x.x.x. is the WAN IP address of the DI-714P+ and 8080 is the port used for the Web Management interface. 30