D-Link DIR-600 User Guide - Page 20
Dynamic - access point mode
UPC - 790069324574
View all D-Link DIR-600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Section 3 - Configuration Internet Setup Dynamic To manually set up the Internet connection, click the Manual Internet Connection Setup button on the Router's opening window. Access Checking this box disables NAT and turns the Router into Point an Access Point only. Mode: Host The Host Name is optional but may be required by some Name: ISPs. The default host name is the device name of the Router and may be changed. MAC Address: The default MAC Address is set to the WAN's physical interface MAC address on the Broadband Router. It is not recommended that you change the default MAC address unless required by your ISP. Clone MAC The default MAC address is set to the WAN's physical Address: interface MAC address on the Broadband Router. You can use the "Clone MAC Address" button to copy the MAC address of the Ethernet Card installed by your ISP and replace the WAN MAC address with the MAC address of the router. It is not recommended that you change the default MAC address unless required by your ISP. Primary / Enter the DNS (Domain Name Server) server IP address Secondary assigned by your ISP. DNS Addresses: MTU: Maximum Transmission Unit - You may need to change the MTU for optimal performance with your specific ISP. D-Link DIR-600 User Manual 20