D-Link DP-101P User Manual - Page 12

DP-101P+ Print Server User's Manual LPT Flash Pattern Error Type steady long flashes Firmware Reload Required continuous on DRAM Error One long, two short flashes Timer INT Error One long, three short flashes Flash Protected One long, four short flashes Flash ID Error One long, five short flashes Flash Erase / Program Error One long, six short flashes LAN Controller Error One long, seven short flashes LAN Memory Error One long, eight short flashes Parallel Controller Error One long, nine short flashes LPT Error steady short flashes EEPROM Error One long, eleven short flashes LAN I/O Base error In the event of a Firmware Reload Required error at startup, proceed according to instructions given in the PS Admin User's Guide ("PS Admin Administration" section, under the heading "Upgrading the Print Server's Internal Firmware"). In the event that any of the other listed error conditions is encountered on startup, contact your dealer for correction of the fault. Operational Test The PS Admin software includes a Print Test function for confirmation of connections and functions. That operational test can be performed after you have completed installation of the PS Admin software, and the PS Admin procedures for configuring the DP-101P+. See instructions given in the PS Admin User's Guide ("Getting Started Setting up Your Print Server" section, under the heading "Testing your Print Server"). 12 Unpacking and Installation