Dell Alienware 25 Gaming AW2521HFL Alienware AW2521HFL Monitor Users Guide - Page 24

Setting up the monitor, Attaching the stand

Get Dell Alienware 25 Gaming AW2521HFL PDF manuals and user guides View all Dell Alienware 25 Gaming AW2521HFL manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Setting up the monitor Attaching the stand NOTE: The stand is not factory-installed. NOTE: The following instructions are only applicable for the stand that was shipped with your monitor. If you are attaching a stand that you purchased from any other source, follow the set up instructions that were included with the stand. CAUTION: The following steps are important to protect your curved screen. Do follow the instructions below to finish up the installation. 1. Remove the stand riser and stand base from the packaging cushion. 2. Align and place the stand riser on the stand base. 3. Open the screw handle at the bottom of the stand base and turn it clockwise to secure the stand assembly. 4. Close the screw handle. 24 | Setting up the monitor

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
24
|
Setting up the monitor
Setting up the monitor
Attaching the stand
NOTE: The stand is not factory-installed.
NOTE: The following instructions are only applicable for the stand that
was shipped with your monitor. If you are attaching a stand that you
purchased from any other source, follow the set up instructions that were
included with the stand.
CAUTION: The following steps are important to protect your curved
screen. Do follow the instructions below to finish up the installation.
1.
Remove the stand riser and stand base from the packaging cushion.
2.
Align and place the stand riser on the stand base.
3.
Open the screw handle at the bottom of the stand base and turn it
clockwise to secure the stand assembly.
4.
Close the screw handle.