Dell C1765NF MFP Laser Printer User Guide - Page 161
Fax Settings, Ring Tone Volume
View all Dell C1765NF MFP Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Fax Settings Purpose: To configure the basic fax settings. Values: Receive Mode Telephone Fax Telephone/Fax Ans Machine/Fax DRPD Auto Rec Fax Auto Rec Fax/Tel Auto Rec Ans/Fax Line Monitor Ring Tone Volume Line Type Tone/Pulse Resend Delay Redial Attempts Redial Delay Available Range: 0-255 seconds Available Range: 0-255 seconds Available Range: 0-255 seconds Off Low Medium High Off Low Medium High PSTN PBX Tone Pulse(10PPS) Available Range: 3-255 seconds Available Range: 0-9 Available Range: 1-15 minutes Automatic fax reception is turned off. You can receive a fax by picking up the handset of the external telephone, and then pressing the remote receive code. Automatically receives faxes. When the printer receives an incoming fax, the external telephone rings for the time specified in Auto Rec Fax/Tel, and then the printer automatically receives a fax. If an incoming call is not a fax, the printer beeps from the internal speaker indicating that the call is a telephone call. The printer can share a telephone line with an answering machine. In this mode, the printer will monitor the fax signal and pick up the line if there are fax tones. If the phone communication is using serial transmission in your country (such as Germany, Sweden, Denmark, Austria, Belgium, Italy, France and Switzerland), this mode is not supported. Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive ring service must be installed on your telephone line by the telephone company. After the telephone company has provided a separate number for faxing with a distinctive ring pattern, configure the fax setup to monitor for that specific ring pattern. Sets the interval at which the printer goes into the fax receive mode after receiving an incoming call. Sets the interval at which the printer goes into the fax receive mode after the external telephone receives an incoming call. Sets the interval at which the printer goes into the fax receive mode after the external answering machine receives an incoming call. Turns off the volume of the line monitor. Specifies the volume of the line monitor, which audibly monitors a transmission through the internal speaker until a connection is made. Turns off the volume of the ring tone. Specifies the volume of the ring tone, which indicates that an incoming call is a telephone call through the internal speaker when Receive Mode is set to Telephone/Fax. Sets the line type to PSTN. Sets the line type to PBX. Sets the dialing type to Tone. Sets the dialing type to Pulse (10 pulse per second). Specifies the interval between transmission attempts. Specifies the number of redial attempts to make when the destination fax number is busy. If you enter 0, the printer will not redial. Specifies the interval between redial attempts. Understanding the Tool Box Menus 159