Dell Force10 S6000 Installation Guide - Page 38
Installing a Fan Module, Replacing a Fan Module
View all Dell Force10 S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
www.dell.com | support.dell.com 3 - PSU 1 Installing a Fan Module CAUTION: DO NOT mix airflow directions. All fans must use the same airflow direction (reverse or normal). If the airflows are mismatched, an error message appears and the system shuts down. 00:02:19:%S6000:0%CHMGR-2-PSU_TYPE_AIRFLOW_MISMATCH: Mismatching PSU airflow detected. Unit 0 shall get shutdown in next 60 seconds if mismatch not rectified. 00:02:19:%STKUNIT0-M:CP%CHMGR-1-PSU_AIRFLOW_COMBO_MISMATCH: Major alarm: Mismatching PSU airflow detected in unit 0 The fan modules in the S6000 are field replaceable. Module slot 0 is on the left side of the switch; module slot 2 is on the right side of the switch. To install a fan module, follow these steps: Step Task 1 Take the fan module out of the shipping box. 2 Use the grab handle to slide the fan module into the bay. Replacing a Fan Module To replace a fan module, follow these steps: Step 1 2 Task CAUTION: You must complete steps 1 and 2 within one minute or the system powers down. Use the grab handle to slide the fan module out of the bay. Use the grab handle on the replacement module to slide it into the bay. 38 | Fans