Dell Force10 Z9000 Installing the Z9000 System - Page 30
Replace a DC Power Supply, follow these steps
View all Dell Force10 Z9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
www.dell.com | support.dell.com Replace a DC Power Supply To replace a DC power supply, follow these steps: NOTE: The PSU slides into the slot smoothly. Do not force the PSU into a slot as this may damage the PSU or the chassis. Step Task 1 Turn the DC power source OFF. 2 Remove the small plastic cover over the DC cable connectors. Do not throw the cover away as you will replace it when you complete the installation. 3 Disconnect the power cable from the PSU. 4 Use the grab handle to slide the PSU out of the power supply bay. 5 Use the grab handle on the replacement unit to slide it into the power supply bay. 6 Replace the small plastic cover over the DC cable connectors. 7 Tighten the securing screw on the side of the PSU. Ensure that the PSU is secure. 8 Attach the power cables. 9 Turn the DC power source ON. 30 | Power Supplies