Dell PowerConnect W-IAP Remote Hardware Installation Guide - Page 65
Cabling a fiber optic module, Cleaning the fiber optic connectors,
View all Dell PowerConnect W-IAP Remote manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
FIGURE 36 Unlocking the bail latch 1 Replacing a copper or fiber optic module 4 1 Bail Latch FIGURE 37 Removing the bail latch NOTE The bail latch may be attached to either the top or the bottom of the mini-GBIC. 4. Grasp the bail latch and pull the copper or fiber optic module out of the port. FIGURE 38 Remove fiber optic module 5. Store the copper or fiber optic module in a safe, static-free place or in an anti-static bag. 6. Install a new copper or fiber optic module in the port. Cabling a fiber optic module For instructions on cabling a fiber optic module refer to "Cabling a fiber optic transceiver" on page 42. Cleaning the fiber optic connectors For instructions on cleaning a fiber optic module refer to "Cleaning the fiber optic connectors" on page 43. PowerConnect B-FCX Switch Hardware Installation Guide 55 53-1002267-01