Dell PowerConnect W-IAP175P Dell Instant 6.1.3.4-3.1.0.0 User Guide - Page 196

This method describes how to set up a DHCP server to send option 43 with Dell PowerConnect W-AirWave information to Dell Instant IAP. This section assumes that option 43 will be sent per scope since option 60 is being shared by other devices as well. NOTE: This scope should be specific to instant and the PXE devices that use options 60 and 43 should not connect to the subnet defined by this scope.This is because you can specify only one option 43 for a scope and if other devices that use option 43 connect to this subnet, they will be presented with Instant specific information. 1. In server 2008, go to Server Manager > Roles > DHCP Server > Your Domain DHCP Server > IPv4. 2. Select a scope (subnet). Scope (10.169.145.0)145 is selected in the example shown in Figure below. 3. Right click and select Advanced and then specify the following options:  Vendor class- DHCP Standard Options  User class- Default User Class  Available options- Select 043 Vendor Specific Info  String Value- Dell InstantAP, tme-store4, 10.169.240.8, Dell123 (which is the AP description, organization string, Dell PowerConnect W-AirWave IP address, Pre-shared key for Dell PowerConnect W-AirWave). Figure 169 Vendor Specific DHCP options Upon completion, the IAP shows up as a new device in Dell PowerConnect W-AirWave, and a new group called tme-store4 is created. Navigate to APs/Devices > New > Group to view this group. 196 | Dell PowerConnect W-AirWave Integration and Management Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0 | User Guide