Dell XPS 720 Owner's Manual - Page 99
Rotate the card retainer back into its original position; push its tip so that its tab clicks into place.
View all Dell XPS 720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
2 3 1 6 4 5 1 card connector (seated) 4 bracket improperly aligned outside of slot 2 card connector (not seated) 5 alignment bar 3 bracket properly aligned within slot 6 alignment guide NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage to the equipment. NOTICE: An incorrectly attached graphics power cable may result in degraded graphics performance. 9 Connect any cables that should be attached to the card. See the documentation for the card for information about the card's cable connections. NOTICE: Before rotating the card retainer back into place, ensure that the tops of all cards and filler brackets are flush with the alignment bar and the notch in the top of each card or filler bracket fits around the alignment guide. 10 Rotate the card retainer back into its original position; push its tip so that its tab clicks into place. 11 If present, lower the card retention device that lays over the installed cards and snap it into place. NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable into the computer. 12 Replace the computer cover (see "Replacing the Computer Cover" on page 159), reconnect the computer and devices to electrical outlets, and then turn them on. Removing and Installing Parts 99