Denon AVR 3300 Owners Manual - Page 37

ENGLISH Clearing "learned" remote control signals and resetting the preset memory 1 Press the USE/LEARN selector button with the tip of a pen, etc., to set the learn mode. 4 START SYSTEM CALL SET CALL DVD VDP 1 2 TV/DBS 4 5 VCR-1 CD 7 8 VCR-2/V.AUX +10 0 RC-860 LEARNED/TX POWER OFF ON / SOURCE TUNER 3 SHIFT PHONO 6 MD / TAPE 9 CHANNEL TV/VCR A / B 2 To clear "learned" remote control signals, set the slide switch to the position at which the signals were "learned". To clear the preset memory seAtUtiDnIOgs, set the slide switch to "VIDEO". AVR/AVC VIDEO 3 Set the slide switch to the position at which the signals were "learned" or at which the preset memory settings were set. DECK MD CD MULTI DVD TV VDP VCR 4 2 1,5 VOLUME DISC SKIP+ SPEAKER DOLBY / DTS SURROUND DIRECT DSP SIMULATION 5CH STEREO INPUT MODE ANALOG STEREO EXT.IN MASTER VOL. AUDIO DECK MD CD MULTI MUTING AVR/AVC VIDEO TUNING DVD TV VDP VCR SYSTEM SETUP SURROUND PARAMETER BAND MODE MEMORY TITLE MENU/GUIDE CH SELECT ENTER SELECT STATUS ON SCREEN DISPLAY RETURN USE/LEARN T.TONE MULTI OUTPUT DVD SET UP 3 Press the SYSTEM CALL SET button, and hold it in for at least four seconds. • When both the START and LEARNED/TX LEDs light simultaneously, all the stored codes are cleared. Light SET 9 OPERATION Before operating 5 Press the USE/LEARN selector button. 1 Refer to "CONNECTIONS" (pages 7 to 14) and check that all connections are correct. 2 Set the remote control unit's slide switch to the AUDIO position. (only when operating with the remote control unit) AUDIO AVR/AVC VIDEO 3 Turn on the power. Press the POWER switch (button). ON / STANDBY ON/STANDBY Light START SYSTEM CALL SET CALL DVD VDP 1 2 TV/DBS 4 5 VCR-1 CD 7 8 VCR-2/V.AUX +10 0 RC-860 LEARNED/TX POWER OFF ON / SOURCE TUNER 3 SHIFT PHONO 6 MD / TAPE 9 CHANNEL TV/VCR A / B 3 (Main unit) (Remote control unit) VOLUME DISC SKIP+ for North American model When pressed, the power turns on and the display lights. The sound is muted for several seconds, after which the unit operates normally. When pressed again, the power turns off, the standby mode is set and the display turns off. Whenever the ON/STANDBY button is in the STANDBY state, the apparatus is still connected on AC line voltage. Please be sure to unplug the cord when you leave home for, say, a vacation. 2 SPEAKER DOLBY / DTS SURROUND DIRECT DSP SIMULATION 5CH STEREO INPUT MODE ANALOG STEREO EXT.IN MASTER VOL. AUDIO DECK MD CD MULTI MUTING AVR/AVC VIDEO TUNING DVD TV VDP VCR SYSTEM SETUP SURROUND PARAMETER for multiple voltage model • ¢ ON/STANDBY The power turns on and "ON/STANDBY" indicator is light. Several seconds are required from the time the power switch is set to the "ON" position until sound is output. This is due to the built-in muting circuit that prevents noise when the power switch is turned on and off. Set the POWER switch to this position to turn the power on and off from the included remote control unit (RC-860). • £ OFF The power turns off and "ON/STANDBY" indicator is off. In this position, the power cannot be turned on and off from the remote control unit. 37