Denon DHT FS5 Owners Manual - English - Page 15
Analog Input Sensitivity Setting, Auto Power Off, Resetting the Microprocessor - manual
UPC - 883795000260
View all Denon DHT FS5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ENGLISH Getting Started Installation Connections Settings Operation Other Functions Troubleshooting Specifications Other Functions Troubleshooting Analog Input Sensitivity Setting Press and hold in [ANALOG (An)] for at least 3 seconds. "Hi ( ) " is shown on the display for about 5 seconds, and the input sensitivity is set to +6 dB. b When [ANALOG (An)] is pressed again and held in for at least 3 seconds, "Lo ( ) " is shown on the display for about 5 seconds, and the input sensitivity is set to 0 dB. b This mode is set to "Lo" upon purchase. If the sound is distorted when the input sensitivity is set to "Hi", set it back to "Lo". Auto Power Off The standby mode is set if there is no input for 10 minutes. Press and hold in [ON/STANDBY] for at least 3 seconds. "Off ( ) " is shown on the display for about 5 seconds, and the auto power off function is canceled. b When [ANALOG (An)] is pressed again for at least 3 seconds, "On ( ) " is shown on the display for about 5 seconds, and the auto power off function is set. b This mode is set to "On" upon purchase. Depending on the device connected, the auto power off function may not work. In this case, set the auto power off function to "Off" and turn the DHT-FS5's power off manually. If a problem should arise, first check the following: 1. Are the connections correct? 2. Is the set being operated as described in the owner's manual? 3. Are the other components operating properly? If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase. Symptom Cause Countermeasure When the power is turned on, • The power cord's plug is not fully plugged in. • Check the insertion of the power cord plug the power indicator does not light and connect securely. and no sound is produced. The power indicator lights but • The position of the input selection button is • Switch to the correct function (input). no sound is produced. inappropriate. • The volume is turned all the way down. • Press [VOLUME+] on the remote control unit. • The mute mode is set. • Cancel the mute mode. • Analog connection cables are not securely • Connect securely. connected. • No digital signal is being input. • Properly select a digital signal input source. No DTS sound isproduced. • DVD player's audio output setting isn't set to • Use the DVD player's default settings. bit stream. • DVD player is not DTS-compatible. • Use a DTS-compatible player. • DHT-FS5's input setting is set to analog. • Use a digital input. No sound is produced from • Subwoofer's output is not connected. subwoofer. • Connect securely. Remote control unit does not • The batteries are flat. • Replace with new batteries. operate. • The remote control unit is too far away. • Operate from closer to the main unit. • There is an obstacle between the main unit • Remove the obstacle. and the remote control unit. • The batteries are inserted in the wrong • Insert the batteries in the proper direction. direction. Page 8 10 10 10 7, 8 10 - - 10 8 2 2 2 2 Resetting the Microprocessor This restores the various settings to as they were upon purchase. Press and hold in [SETUP] for at least 3 seconds. "RESET ( ) " is shown on the display for about 5 seconds, and the settings are restored to as they were upon purchase. 11