Denon DN-HC5000 Operating Instructions - Page 17

ENGLISH 4. Seamless Loop/Hot Start/Stutter/Trim Operation display (refer to the section describing the display) q, w, y e r t, y 1. Setting the A point (loading the Hot Start data) q Press the A1 or A2 button to set the A point and Hot Start data loading starts. • A1 and A2 buttons can be used separately for each Hot Start. • When an A point is set, the corresponding A button and " " display light and that button is set to the Hot Start mode. 2. Starts Hot Start w When A1 or A2 button is pressed, Hot Start playback starts from the corresponding A point. 3. Setting the B point for Seamless Loop e When the B button is pressed after setting the A point or after starting Hot start playback, the B point is set and Seamless Loop playback starts from the A point. • The B button works with respect to the A point operated before the B button was pressed. • If the B button is pressed during Seamless Loop playback or after EXIT playback, the B point moves to the point at which the button was pressed. •When the B point is set, the B and " " displays light. 4. Playing Seamless Loops • When the B1 point for A1 is detected after playback started from A1 point, playback returns to A1 point with seamless. While A1 to B1 looping, B2 point for A2 ignored. • When the B2 point for A2 is detected after playback started from A2 point, playback returns to A2 point with seamless. While A2 to B2 looping, B1 point for A1 ignored. 8. Trim For instructions on the trim function, refer to the manual of the DN-D4000/D4500/BU4500. NOTE: If the setting made at the "CD Mode Sel" presetting does not correspond to what is actually connected, the unit may not operate properly. 5. Exit/Reloop r In Seamless Loop playback, you can force exit from or return to the loop. EXIT: While the Seamless Loop playback, press the EXIT/ RELOOP button to exit from loop. DN-D4000/D4500/ BU4500 continues playback after the B point. RELOOP: When the EXIT/RELOOP button is pressed after exit the loop, Seamless Loop playback resumes from the A point. 6. Stutter • A1 and A2 points can be also used for Stutter playback. t To enable stutter playback, press FLIP button for A1/A2 buttons, then " " display turns off. Press the FLIP button to switch between the Hot Start/Seamless Loop and Stutter modes. 7. Clear the A1/A2 point y While pressing the FLIP button, press the A1 or A2 button to clear the corresponding A and B points. Or press the FLIP button for more than 1 sec to clear both A1 and A2 points at once. Quickly pressing the "FLIP" button first and then A1, A2 or B buttons will clear these points individually. 13 ENGLISH