Dewalt DCS350B Instruction Manual - Page 10

Charge indicators: DCB107, DCB112, DCB113, DCB115, DCB118 Charging Never operate the charger if the fan does not operate properly or if ventilation slots are blocked. Do not permit foreign objects to enter the interior of the charger. English Fully Charged LITHIUM-ION BATTERY PACKS ONLY Hot/Cold Pack Delay* Li-Ion tools are designed with an Electronic Protection System that will protect the battery pack against overloading, overheating or deep * DCB107, DCB112, DCB113, DCB115, DCB118: The red light will continue to blink, but a yellow indicator light will be illuminated during this operation. Once the battery pack has reached an appropriate temperature, the yellow light will turn off and the discharge. The tool will automatically turn off if the Electronic Protection System engages. If this occurs, place the lithium-ion battery pack on the charger until it is fully charged. charger will resume the charging procedure. Wall Mounting The compatible charger(s) will not charge a faulty battery pack. The DCB107, DCB112, DCB113, DCB115, DCB118 charger will indicate faulty battery pack by refusing to light or by These chargers are designed to be wall mountable or to sit upright displaying a problem pack or charger blink pattern. NOTE: This could also mean a problem with a charger. If the charger indicates a problem, take the charger and battery pack to be tested at an authorized service center. HOT/COLD PACK DELAY on a table or work surface. If wall mounting, locate the charger within reach of an electrical outlet, and away from a corner or other obstructions which may impede air flow. Use the back of the charger as a template for the location of the mounting screws on the wall. Mount the charger securely using drywall screws (purchased separately) at least 1" (25.4 mm) long, with a screw head diameter of When the charger detects a battery pack that is too hot or too cold, 0.28-0.35" (7-9 mm), screwed into wood to an optimal depth leaving it automatically starts a Hot/Cold Pack Delay, suspending charging approximately 7/32" (5.5 mm) of the screw exposed. Align the slots until the battery pack has reached an appropriate temperature. The charger then automatically switches to the pack charging mode. This on the back of the charger with the exposed screws and fully engage them in the slots. feature ensures maximum battery pack life. A cold battery pack will charge at a slower rate than a warm battery pack. The battery pack will charge at that slower rate throughout the entire charging cycle and will not return to maximum charge rate even if the battery pack warms. The DCB118 charger is equipped with an internal fan designed to cool the battery pack. The fan will turn on automatically when the Charger Cleaning Instructions WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush. Do not use water or any cleaning solutions. Important Charging Notes battery pack needs to be cooled. 1. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 65 °F and 8