Dewalt DWMIIIFS Instruction Manual - Floor Kit - Page 1

PRE-FINISHED FLOORING KIT INSTALLATION INSTRUCTIONS FOR MODELS: DWMIIIFS PARTS INCLUDED IN THIS KIT: 1- PRE-FINISHED FLOORING FOOT (171142) 2- FOOT SHIMS (159828) 2- SHAFTS (164188) 2- ROLLERS (171143) 2- O-RINGS (850240) EYE PROTECTION which conforms to ANSI specifications and provides protection against flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when loading, operating or servicing this tool. Eye protection is required to guard against flying fasteners and debris, which could cause severe eye injury. The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment must conform to the requirements of the American National Standards Institute, ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded spectacles and face shields alone do not provide adequate protection. Always disconnect air supply: 1.) Before making adjustments; 2.) When servicing the tool; 3.) When clearing a jam; 4.) When tool is not in use; 5.) When moving to a different work area, as accidental actuation may occur, possibly causing injury. Do not use gasoline or similar highly flammable liquids to clean the nailer. Vapor in the nailer could be ignited by a spark causing the tool to explode. When working on air tools, note the warnings and cautions in this guide and in the Operation and Maintenance Manual covering the specific tool. USE EXTRA CARE WHEN EVALUATING PROBLEM TOOLS. 9R212755 3/16