Dewalt DWMIIIFS Instruction Manual - Floor Kit - Page 2

Shims Recommended - parts

Get Dewalt DWMIIIFS PDF manuals and user guides View all Dewalt DWMIIIFS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

INSTALLATION INSTRUCTIONS FOR MODELS: DWMIIIFS G Disconnect tool from air supply before attempting any parts disassembly. 1. Remove the flat head cap screws and plastic spacer located on the under side of the tool. Plastic Spacer Flat Head Cap Screws 2. Install the pre-finished flooring foot and the proper number of shims (see chart). Shims Recommended Flooring Thickness 1/2" 3/4" DWMIIIFS 1 0 Shim (as required) NOTE: FLOORING PRODUCTS WILL VARY AND THE USER MUST INSURE THE THE TOOL IS SHIMMED PROPERLY ACCORDING TO THE FLOORING PRODUCT BEING INSTALLED. ONCE PROPERLY SHIMMED, ONLY THE FOOT WILL CONTACT THE FLOORING. 3. Reinstall the flat head cap screws. 4. Roller adjustment: the tool is shipped with rollers set-up for 5/8"- 3/4" range flooring. For 1/2"- 9/16" range flooring remove o-rings, shafts, rollers and re-install rollers in upper holes. Note: If desired or if proper range of adjustment cannot be achieved, foot may be used without rollers. Roller settings 1/2"- 9/16" flooring 5/8"- 3/4" flooring

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
NOTE: FLOORING PRODUCTS WILL VARY AND THE USER MUST INSURE THE THE TOOL IS SHIMMED
PROPERLY ACCORDING TO THE FLOORING PRODUCT BEING INSTALLED. ONCE PROPERLY SHIMMED,
ONLY THE FOOT WILL CONTACT THE FLOORING.
3. Reinstall the flat head cap screws.
4. Roller adjustment: the tool is shipped with
rollers set-up for 5/8”- 3/4” range flooring.
For 1/2”- 9/16” range flooring remove o-rings,
shafts, rollers and re-install rollers in upper
holes.
Note: If desired or if proper range of
adjustment cannot be achieved, foot may be
used without rollers.
INSTALLATION INSTRUCTIONS FOR MODELS: DWMIIIFS
Disconnect tool from air supply before attempting any parts disassembly.
G
1. Remove the flat head cap screws and
plastic spacer located on the under side
of the tool.
Plastic Spacer
Flat Head Cap Screws
Shim (as
required)
2. Install the pre-finished flooring foot and the proper
number of shims (see chart).
Shims Recommended
Flooring
Thickness
1/2”
3/4”
DWMIIIFS
1
0
Roller settings
1/2”- 9/16” flooring
5/8”- 3/4” flooring