Dymo LabelWriter SE450 Label Printer Technical Reference - Page 29
ESC F 1 n Feed n Lines, ESC g Set Print Temperature to High, ESC h Set Print Speed to Fast, ESC
View all Dymo LabelWriter SE450 Label Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Commands None ESC F 1 n Feed n Lines Description Provided for LabelWriter raster compatibility. The command is used to feed the next "n" lines on the label. This command requires two bytes: the first byte is always 1, the second byte is the feed line value. Note that this command functions identically to the ESC J command. See Also ESC J ESC g Set Print Temperature to High Used to adjust the printing strobe. This command is also supported by the LabelWriter SE300 and the LabelWriter 400 and 450 series printers. Expression ASCII ESC g Decimal 27 103 Hex 1B 67 Parameters None ESC h Set Print Speed to Fast Used to set the printing speed to fast, which is the default speed. This command is also supported by the LabelWriter 400 and 450 series of printers. ESC i Set Printing Speed to Barcode Used to adjust the printing speed to slow for better print quality for barcodes and graphics. This command is supported by the LabelWriter 400 and 450 series printers. ESC J Feed n Lines Description Feeds n number of sublines (n/203 inch). This command causes the printer to print data stored in the buffer and then feed n number of dot lines. This command is similar to the GS d command. See Also GS d Expression 23