Dymo Rhino 1011 Metal Tape Embosser User Guide - Page 4
Loading the Label Tape - plastic tape embosser
View all Dymo Rhino 1011 Metal Tape Embosser manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Loading the Label Tape The DYMO M1011 is set to emboss non-adhesive aluminium or plastic tape. To load the tape roll 1. Hold the labelmaker in your left hand. 2. Open tape door (A). 3. Insert roll of tape allowing the end to extend about 5 cm (2") through the tape slot. 4. Close the tape door. 5. Feed the tape between the two rollers (B). 6. Squeeze the embossing handle (F) half-way (one click) several times to ensure the tape is inserted all the way. 4
4
Loading the Label Tape
The DYMO M1011 is set to emboss non-adhesive aluminium or
plastic tape.
To load the tape roll
1.
Hold the labelmaker in your left hand.
2.
Open tape door (A).
3.
Insert roll of tape allowing the end to extend about 5 cm (2")
through the tape slot.
4.
Close the tape door.
5.
Feed the tape between the two rollers (B).
6.
Squeeze the embossing handle (F) half-way (one click) several
times to ensure the tape is inserted all the way.