Dymo Rhino 1011 Metal Tape Embosser User Guide - Page 5
Cutting the Tape
View all Dymo Rhino 1011 Metal Tape Embosser manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
I M Cutting the Tape To cut the tape 1. Squeeze the embossing handle half-way, several times until the tape extends from the front of the cutting assembly (M) by at least 1 cm (1"). Before cutting the tape, make sure the end of the tape extends beyond the edge of the cutting assembly so you can easily pull the label out. Otherwise, a tape jam may occur. 2. Lift the cutting handle (I) gently until it is vertical to cut the tape. 5
5
Cutting the Tape
To cut the tape
1.
Squeeze the embossing handle half-way, several times until the
tape extends from the front of the cutting assembly (M) by at least
1 cm (1").
Before cutting the tape, make sure the end of the tape
extends beyond the edge of the cutting assembly so you can easily
pull the label out. Otherwise, a tape jam may occur.
2.
Lift the cutting handle (I) gently until it is vertical to cut the tape.
I
M