EVGA 141-BL-E760-A1 User Guide - Page 22
Connecting IDE Hard Disk Drives
UPC - 843368010157
View all EVGA 141-BL-E760-A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
EVGA X58 SLI CLASSIFIED Motherboard Connecting IDE Hard Disk Drives The IDE connector supports Ultra ATA 133/100/66 IDE hard disk drives. 1. Connect the blue connector (the cable end with a single connector) to the motherboard. 2. Connect the black connector (the cable with the two closely spaced black and gray connectors) to the Ultra ATA master device. 3. Connect the gray connector to a slave device. If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are attached to the same cable, the maximum transfer rate between the drives may be reduced to that of the slowest drive. IDE Connector Board Edge 24