Electrolux E30GF74GPS Use and Care Manual - Page 27
Cleaning The Burner Grates, Burner Caps, Burner Heads, Simmer Plate And Griddle
View all Electrolux E30GF74GPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Care & Cleaning 27 CLEANING THE BURNER GRATES, BURNER CAPS, BURNER HEADS, SIMMER PLATE AND GRIDDLE The Burner Grates, Burner Caps, Burner Heads, simmer plate and griddle should be routinely cleaned. Keeping the burner ports clean will prevent improper ignition and an uneven flame. Refer to the following instructions: To Remove and Replace the Surface Burner Grate, Surface Burner Cap and Surface Burner Head - Remove in the following order: (1st) Surface Burner Grate, (2nd) Surface Burner Cap, (3rd) Surface Burner Head; 18000BTU Surface Burner Grate 1st Surface 2nd Dual Flame Burners Only (See Figure). Burner Cap 3rd Surface Reverse the procedure above to replace the Surface Burner Cap, Burner Head Surface Burner Head and Surface Burner Grate. Do not remove any burner parts from the cooktop until the burner parts have Electrode completely cooled and are safe to handle. Do not operate the surface burners without the Surface Burner Caps, Surface Burner Heads and Surface Burner Grates properly in place. To Clean the Burner Caps, Burner Heads, Burner Grates, Simmer Plate and Griddle - Use a soap-filled scouring pad or a mild abrasive cleaner to clean the surface burner caps and surface burner heads. The Grates, Simmer Plates and Griddle are designed to be Dishwasher safe for cleaning. The ports (or slots) around the burner heads must be routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle to clean the slots or holes being careful not to damage the electrode. For proper flow of gas and ignition of the burner-DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. ALWAYS make sure that the surface burner cap, the surface burner head and the surface burner grate are properly in place whenever a surface burner is in use. Surface Burner Grate Surface Burner Caps Surface Burner Heads THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop. ! CAUTION - Use caution when replacing the burner head so the electrode is not damaged. A damaged electrode may cause a delayed ignition or prevent the burner from igniting - Any additions, changes or conversions required in order for this appliance to perform satisfactorily must be made by a qualified service technician.