Electrolux EFLS527UTT Complete Owners Guide English - Page 45
PROBLEM, POSSIBLE CAUSES, SOLUTIONS, Care and, Cleaning
View all Electrolux EFLS527UTT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Troubleshooting 45 PROBLEM POSSIBLE CAUSES SOLUTIONS Washer does not • Electrical power cord may start not be plugged in or con- nection may be loose. • House fuse blown, circuit breaker tripped, or a power outage has occurred. • Make sure plug fits tightly in wall outlet. • Reset circuit breaker or replace fuse. DO NOT increase fuse capacity. If problem is a circuit overload, have it corrected by a qualified electrician. If problem is a power outage, call local electric company. • Action of pressing start/ pause button on "touch screen" style console not recognized. • Press start/pause button with bare fingertip. • Water supply faucets are not • Turn on water supply faucets. turned on. • Motor is overheated. Washer • It will automatically restart after motor will stop if overheated. a cool down period of up to 30 minutes (if washer has not been manually turned off). • Door may be open. Unit will • Ensure door is closed. not operate with door open. • Light next to start/pause • Press start/pause button to con- button is flashing indicating unit is paused. tinue the cycle. WATER Water collects in • This is a result of the wash- • Wipe and dry the gasket to remove folds of the door ing action and is part of water and any debris remaining in gasket at the the normal operation of the the gasket after use. end of the cycle washer. Water collects in • This is a result of the siphon- • Water may be removed by removing bleach and fab- ing action and is part of the dispenser drawer (see Care and ric softener com- the normal operation of the Cleaning in this guide) and draining partments washer. water into the empty drum or sink. Wash load too • Washer is overloaded. • DO NOT overload washer. See wet after spin Operating Your Washer. • Load is too small. • Add 1 or 2 similar items to help balance load. • Load is out of balance. • Rearrange load to allow proper spinning. • Drain hose is kinked. • Straighten drain hose. Water does not • Water supply is not ad- • Check another faucet in the house. enter washer or equate in area. Wait until water supply and pres- it enters slowly sure increase. • Water supply faucets are not • Fully open hot and cold faucets. completely open. • Water is being used else- • Avoid running water elsewhere where in the house. Water while washer is filling. pressure must be at least 30 psi (260 kPa). • Water inlet hoses are kinked. • Straighten hoses. • Water inlet screens plugged. • Remove hose from inlets and clean screens.