Electrolux EFLS527UTT Complete Owners Guide English - Page 7

Pre-Installation Requirements 7  Installation Checklist Shipping Hardware ˆˆ Foam shipping support (under wash tub) removed and stored ˆˆ Shipping bolts and spacers removed from rear of appliance and stored ˆˆ Hole plugs (shipped in bag in drum) installed in holes in backsheet Leveling ˆˆ Washer is level, side-to-side and front-to-back ˆˆ Cabinet is sitting solid on all corners Water Supply ˆˆ Use only new hoses and verify rubber sealing washers are installed ˆˆ HOT supply is connected to HOT inlet and COLD supply is connected to COLD inlet ˆˆ HOT and COLD water supply turned on ˆˆ No leaks present at water supply connections or appliance inlet connections - recheck in 24 hours Drain ˆˆ Stand pipe or wall drain height minimum 24" ˆˆ Verify anti-siphon disc is attached toward end of drain hose ˆˆ Drain hose secured in place with cable tie (shipped in drum) Door Reversal ˆˆ Follow detailed instructions in this guide ˆˆ Test hinge and latch for function Electrical Power ˆˆ House power turned on ˆˆ Washer plugged in Final Checks ˆˆ Installation instructions and Use & Care Guide read thoroughly ˆˆ Door locks and water enters drum when cycle starts ˆˆ Registration card sent in Tools and materials needed for installation: OR OR AND AND Adjustable wrench 3/8" or 10 mm box wrench Ratchet and socket set Adjustable pliers Carpenter's level Inlet Hose NOTE (x2) Hoses are not included with washer purchase. Electrical system requirements CIRCUIT - Individual, properly polarized and grounded 15 amp. branch circuit fused with 15 amp. time delay fuse or circuit breaker. POWER SUPPLY - 2 wire, with ground, 120 volt single phase, 60 Hz, Alternating Current. OUTLET RECEPTACLE - Properly grounded 3-prong receptacle to be located so the power supply cord is accessible when the washer is in an installed position.