Electrolux EIDW1805KS Installation Instructions (English)

Electrolux EIDW1805KS Manual

Electrolux EIDW1805KS manual content summary:

  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 1
    instructions with your Owner's Manual for future reference. • Skill Level- Installation of this dishwasher re- quires basic mechanical and electrical skills. Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the ELECTROLUX
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 2
    Installation Preparation PARTS SUPPLIED : … Two #8 Phillips flat head wood screws, 5/8" long to secure dishwasher to underside of countertop (in literature package). … Two Phillips head, color matched toekick screws (in literature package). 2 Wood Screws 2 Color Matched Toekick Screws Screw Type
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 3
    dishwasher must be fully enclosed on the top, sides and back, and must not support any part of the enclosure Clearance: When installed into a corner, allow 2" min. clearance between dishwasher dishwasher. Figure D Install waste tee or disposer and air gap according to manufacturer's instructions.
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 4
    on the appliance Grounding Instructions - Power Cord a qualified electrician or service representative if you are dishwasher. • For cable direct connections the cable must be routed as shown in Figure E. Cable must extend a minimum of 24" from the rear wall. • For power cord connections, install
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 5
    Installation Instructions PREPARE HOT WATER LINE • The line may enter from either strongly recommended and may be required by local codes.) • Water connection is on the left side of the dishwasher. Install the hot water inlet line, using no less than 3/8" O.D. copper tubing. Route the line as shown
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 6
    Installation Instructions STEP 2 ADJUST LEVELING LEGS • Move the dishwasher close to the installation location and lay it on its back. STEP 4 INSTALL 90° ELBOW • Wrap 90° elbow with thread seal tape. • Install a 90° elbow onto the water valve. • Do not over tighten 90° elbow, water valve bracket
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 7
    Installation Instructions STEP 5 POSITION WATER LIND AND HOUSE WIRING • Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher. STEP 7 SLIDE DISHWASHER PAR- TIALLY INTO CABINET DO NOT PUSH AGAINST FRONT
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 8
    Installation Instructions STEP 8 POSTION DISHWASHER UNDER COUNTERTOP • Check to be sure that wires are secure under the dishwasher and not pinced or in contact with door springs or other dishwasher components TIP: Check tub insulation blanket, if equipped. It should be positioned so it is not
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 9
    Installation Instructions STEP 10 SECURE DISHWASHER TO COUNTERTOP OR CABINET In this step you will need the 2 Phillips special head screws set aside prior to Step 1. The dishwasher must be secured to the countertop or the cabinet sides. When countertops are mad of wood, use Method 1. When
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 10
    PROPTER DRAIN OPERATION.. Waste Tee Installation Disposer Installation Figure X IMPORTANT - When connecting drain line to disposer check to be sure that drain plug has been removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE. TIP: Avoid unnecessary service call charges. Always be sure
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 11
    after installing your dishwasher to avoid charges for a service call that is not covered by your warranty: … Check to be sure power is OFF. … Open door and remove all foam and paper package … Locate the Owner's Manual in the literature package. … Read the Owner's Manual for operating instructions
  • Electrolux EIDW1805KS | Installation Instructions (English) - Page 12
    Installation Instructions STEP 15 DISHWASHER WET TEST … Turn on power supply (or plug power cord into outlet, if equipped). … Turn dial to Normal "Wash" position. … Close door. … Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

Installation
Instructions
Built-In
Dishwasher
If you have questions,
call 1-877-4ELECTROLUX (US) or 1-877-435-3287,
1-800-
245-8352 (Canada) or visit our website at:
www.electroluxappliances.com
IMPORTANT
The dishwasher
MUST be installed to allow for future removal from
the enclosure if service is required.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories
– See the Owner's Manual
for available custom panel kits.
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGs
shown throughout these instructions.
While per-
forming installations described in this booklet,
gloves, safety glasses or goggles should be worn.
BEFORE YOU BEGIN
Read these Instructions completely and
carefully.
IMPORTANT
Observe all
governing codes and ordinances.
Note to Installer
– Be sure to leave these instruc-
tions for the consumer's and local inspector's use.
Note to Consumer
– Keep these instructions with
your Owner's Manual for future reference.
Skill Level
– Installation of this dishwasher re-
quires basic mechanical and electrical skills.
Proper installation is the responsibility of the
installer.
Product failure due to improper installa-
tion is not covered under the ELECTROLUX
Appliance Warranty.
Completion Time
– 1 to 3 Hours.
New installa-
tions require more time than replacement installa-
tions.
WARNING
To reduce the risk of electrical shock,
fire, or injury to persons, the installer
must ensure that the dishwasher is
competely enclosed at the time of
installation.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.