Electrolux EIDW1805KS Installation Instructions (English) - Page 6
Installation Instructions
View all Electrolux EIDW1805KS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Instructions STEP 2 ADJUST LEVELING LEGS • Move the dishwasher close to the installation location and lay it on its back. STEP 4 INSTALL 90° ELBOW • Wrap 90° elbow with thread seal tape. • Install a 90° elbow onto the water valve. • Do not over tighten 90° elbow, water valve bracket could bend or water valve fitting could break. • Measure installation height and dishwasher height. Extend leveling legs out from the dishwasher base, 1/4" less than installation height. STEP 3 REMOVE KICKPLATE • Remove the 4 toekick screws. Lift off the 2 piece toekick. • Position the end of the elbow to face the rear of the dishwasher. 6
6
Installation Instructions
STEP 3
REMOVE KICKPLATE
•
Remove the 4 toekick screws.
Lift off the 2
piece toekick.
STEP 4
INSTALL 90° ELBOW
•
Wrap 90° elbow with thread seal tape.
•
Install a
90° elbow onto the water valve.
•
Do not over tighten 90° elbow, water valve
bracket could bend or water valve fitting could
break.
•
Position the end of the elbow to face the rear of
the dishwasher.
STEP 2
ADJUST LEVELING
LEGS
•
Move the dishwasher close to the installation
location and lay it on its back.
•
Measure installation height and dishwasher
height.
Extend leveling
legs out from the
dishwasher base, 1/4" less than installation
height.