Electrolux EWFLW65HIW Use and Care Guide - Page 30

30 Operating User Interface Features Setting Preferences, con't SYSTEM CLEAN To clean and freshen the washer, perform the SYSTEM CLEAN cycle. If you wish to begin the cycle, press select when prompted. The next screen will instruct you to remove all items from the wash drum, fill the bleach dispenser and press start. This maintenance cycle uses hot water and two rinses to remove residue that may cause odor. NOTE The washer will automatically prompt you to run the SYSTEM CLEAN cycle every 50 cycles. You may press the button under EXIT to manually perform the cycle at another time. RESET Press the buttons indicated to restore only cycle settings, reset only factory preferences (users, language, brightness, volume, etc.) or restore all factory defaults (both cycle settings and factory preferences). Press the button under EXIT to return to normal operation or press the cancel button to turn the washer off without making any changes. If you do not make a selection within 30 seconds the washer will return to normal operation without any changes. If you reset all settings, INSTALL CYCLE will be displayed as though the washer were just turned on for the first time. You may press the button under CANCEL if you do not wish to rerun the INSTALL CYCLE. CONTRAST Press the button beneath plus (+) or minus (-) symbols to increase or decrease the contrast of the display. Press select to accept the change or press the button under EXIT to return to normal operation without any changes.