Electrolux EWMGD65HIW Installation Instructions - Page 19

Reversing Door 19 Preparing to reverse door swing 1 Be sure you have adequate swing area before reversing door 2 You will need a screw driver with a t2 square bit. 3 Protect flat woik surface, such as top of dryer or11)or near dryer, with a soft cloth or towel. 4 Be sure dryer Is unplucged from power source) th WARNING ELECTRICAL SHOCK HkZARD Failureto disconnect power source Iatom savicIng could result in persona injury or eve death. Removing door and hardware Tools healed: Scrwedrivers with square straight bit A) Removing Trim Ring 1 Open door to 90 dogma angle. 2 Remove and save trim plug and long, course-thread, panheed screw. B)Removing Door from Front Panel 1 Reopen door to 90 degree angle. 2 Remove 2 shdrt, coursathread, panhead screws. A 3 Close door 4 Rotate 000r 01M appoidtreddy W countecCIOCkWlse and pull Wig away from dear. 3 Mlle supporting dear with the other hand, remove 3 short, line-thread, ccunter-sunk screws. 4 Gently place door/ace down on flat, covered WCCIC surface.