Epson BrightLink 536Wi Installation Guide - Short-Throw Wall Mount (ELPMB45) - Page 27

Adjust the arm length, 8. Connect the power cord and other cables to the projector

Get Epson BrightLink 536Wi PDF manuals and user guides View all Epson BrightLink 536Wi manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

7. Adjust the arm length 1. Loosen the screw on the arm ( ). 2. Adjust the length of the arm using the measure on the bottom to match the projection distance recommended in "Positioning the Projector" on page 12 ( ). 3. After adjusting the length, secure the arm position temporarily by tightening the screw on top ( ). 8. Connect the power cord and other cables to the projector Connect any necessary cables such as the power cord, computer cable, HDMI cable, audio cables, and USB cable to the projector. If you are planning to run the cables inside the wall, make sure you follow all local electrical codes. If you are running the cables outside the wall, use a cable management system to keep the cables from 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
27
7.
Adjust the arm length
1.
Loosen the screw on the arm (
).
2.
Adjust the length of the arm using the measure on the bottom to match the projection distance
recommended in “Positioning the Projector” on page 12 (
).
3.
After adjusting the length, secure the arm position temporarily by tightening the screw on
top (
).
8.
Connect the power cord and other cables to the projector
Connect any necessary cables such as the power cord, computer cable, HDMI cable, audio cables, and
USB cable to the projector.
If you are planning to run the cables inside the wall, make sure you follow all local electrical codes. If
you are running the cables outside the wall, use a cable management system to keep the cables from