Epson BrightLink Solo 3 Interactive Module ELPIU03 Users Guide - Page 17

Calibrating 17 Click the pen icon in the Dock, select Calibrate from the menu bar, then select Calibrate (Normal) or Calibrate (Advanced). b After you read the message about calibration, click OK. A flashing circle is displayed in the upper left corner of your projected image. c Touch the center of the circle with the tip of the pen. The circle stops flashing. You see another circle on the right. d Touch the center of the circle again, then repeat. When you get to the end of the row, the next circle appears at the left edge of a new row. a • For the most accurate calibration, make sure you hold the pen at an angle to the projection surface and touch the center of the circle. • Make sure you are not blocking the signal between the pen and the interactive receiver. • Do not press the button on the pen while calibrating. • If you make a mistake or want to stop calibrating, press [Esc] on your computer keyboard. Then restart the calibration process as described above. e Continue until all of the circles stop flashing.