Fluke 192C FE 192,196,199 C Users Manual - Page 63
Triggering on Edges, Trigger Options, Free Run, On Trigger, Single Shot, Noise, reject Filter
View all Fluke 192C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Triggering on Edges If the signal is instable or has a very low frequency, use edge triggering to obtain full manual trigger control. To trigger on rising edges of the input A waveform, do the following: 1 Display the TRIGGER key labels. 2 Open the Trigger Options menu. 3 Open the Trigger on Edge menu. When Free Run is selected, the test tool updates the screen even if there are no triggers. A trace always appears on the screen. 5 Triggering on Waveforms Triggering on Edges When On Trigger is selected, the test tool needs a trigger to display a waveform. Use this mode if you want to update the screen only when valid triggers occur. When Single Shot is selected, the test tool waits for a trigger. After receiving a trigger, the waveform is displayed and the instruments is set to HOLD. In most cases it is advised to use the Free Run mode: 4 Select Free Run, jump to Noise reject Filter. 5 Set Noise reject Filter to Off. 6 Set NCycle to Off (C versions) Observe that the key labels at the bottom of the screen have adapted to allow further selection of specific edge trigger settings: 55