Foxconn A9DA English Manual. - Page 22

2 Front Panel Connector : FP1 This motherboard includes one connector for connecting the front panel switch and LED Indicators. Hard Disk LED Connector (HDD-LED) Connect to the chassis front panel IDE indicator LED. It indicates the active status of the hard disks. This 2-pin connector is directional with +/- sign. Reset Switch (RESET-SW) Attach the connector to the Reset switch on the front panel of the case; the system will restart when the switch is pressed. Power LED Connector (PWR-LED) Connect to the power LED indicator on the front panel of the chassis. The Power LED indicates the system's status. When the system is in operation (S0 status), the LED is on. When the system gets into sleep mode (S1) , the LED is blinking; When the system is in S3/S4 sleep state or power off mode (S5), the LED is off. This 2-pin connector is directional with +/- sign. Power Switch Connector (PWR-SW) Connect to the power button on the front panel of the chassis. Push this switch allows the system to be turned on and off rather than using the power supply button. 12 + + HDD-LED - PWR-LED - RESET-SW PWR-SW NC EMPTY 9 10 FP1 Serial ATA Connectors : SATA1_SATA2, SATA3_ SATA4, SATA5_ESATA The Serial ATA connector is used to connect with SATA Hard Disk or CD devices which supporting this feature. The current Serial ATA III interface allows up to 600MB/s data transfer rate. Note: There will be an ESATA cable in the package, you can use it to connect an ESATA hard disk to the upper SATA port of SATA5_ESATA on the motherboard(as depicted). ESATA 1 GND TX+ TXGND RXRX+ GND SATA1_SATA2/SATA3_SATA4/ SATA5_ESATA 15