Frigidaire FCRE3052BS Complete Owners Guide - Page 19

19 BEFORE SETTING OVEN CONTROLS Oven Vent Location The oven is vented as shown below. When the oven is on, warm air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block oven vent. Never close off the openings with aluminium foil or any other material. Steam or moisture may appear near the oven vent. This is normal. Types of Oven Rack Figure 8: Oven vent WARNING Protective Liners - Do not use aluminum foil or any other material or liners to line the oven bottom, walls, racks or any other part of the range. Doing so will alter the heat distribution, produce poor baking results, and possibly cause permanent damage to the oven interior. Improper installation of these liners may result in risk of electric shock or fire. During self clean, temperatures in the oven will be hot enough to melt foil. CAUTION Always use pot holders or oven mitts when using the oven. When cooking, the oven interior, oven exterior, oven racks, and cooktop will become very hot which can cause burns. Remove all oven racks before starting a self clean cycle. If oven racks are left inside the oven during a cleaning cycle, the slide ability of the oven racks may be damaged and all of the oven racks will lose their shiny finish. To prevent possible damage to the oven, do not attempt to close the oven door until all the oven racks are fully positioned back inside the oven cavity. flat oven rack Figure 7: Oven rack types Flat oven racks may be used for most cooking needs and may be placed in most oven rack positions. Removing, Replacing, and Arranging Flat or Offset Oven Racks Always arrange the oven racks when the oven is cool. To remove - Pull the oven rack straight forward until it reaches the stop position. Lift up front of oven rack slightly and slide out. To replace - Place the oven rack on the rack guides on both sides of oven walls. Tilt the front of oven rack upward slightly and slide the oven rack back into place. Be sure oven racks are level before using.