Frigidaire FFHI1832TS Complete Owner s Guide - Page 8

DOOR REMOVAL/REVERSAL INSTRUCTIONS 4. Lift refrigerator door off of bottom hinge and set aside. 5. Remove center hinge and shim by removing inside screw and loosening two outside screws enough to allow hinge and shim to slide out. Tighten screws. 6. Loosen two outside screws on opposite side of refrigerator, remove inside screw and install center hinge. Door Stop Screw Door Stop Washer Shim Hinge Pin Center Hinge Door Stop Screw Door Stop Washer Hinge Pin Bottom Hinge Screws Toe Grille OR Hinge Hole Plug Screws Handle Hole Plug Lower 7. Remove three screws on bottom hinge and anti-tip bracket (if equipped) with ⅜" socket wrench. 8. Remove toe grille support and screws (if equipped). WARNING When reversing the door swing: You MUST move the anti-tip bracket to align with the hinges of the door and install the toe grille support for proper balance. Failure to do so will result in injury. 9. Install bottom hinge and anti-tip bracket (if equipped) on opposite side with the three screws removed from step 7. 10. Unscrew bottom hinge pin using adjustable wrench. Move hinge pin to other hole in hinge and tighten with adjustable wrench. 11. Install toe grille support and screws on opposite side (if equipped). 8 Anti-tip Bracket 12. Reverse door handles (see Handle Installation section). 13. Move freezer and refrigerator door stops to opposite side. Before starting screws, use an awl to puncture the foam. 14. Position refrigerator door onto bottom hinge pin and screw center hinge pin through center hinge into top of door. Close refrigerator door to help align hinge hole. 15. Tighten center hinge pin with adjustable wrench. 16. Remove cabinet and hinge hole plugs and move to opposite side. 17. Lower freezer door onto center hinge pin. 18. Close freezer door. Lift up on handle side of door and grasp the thinnest part of the top hinge cover (which was removed in Step 2) and insert the thickest part between the doors on the handle side approximately 3 inches from the outside edge. This will ensure proper spacing.