Frigidaire FFHI1832TS Complete Owner s Guide - Page 9
Important
View all Frigidaire FFHI1832TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
DOOR REMOVAL/REVERSAL INSTRUCTIONS 19. Tighten the top hinge screws and check door gasket for open seal condition (see graphic). Look for open areas between the gasket and the cabinet flange. 20. After the screws have been tightened, replace the top hinge cover. 21. Remove the toe grille cover corresponding with the door hinge bracket from the toe grille and attach the opposite toe grille cover that was saved earlier over the opening on the side corresponding with the toe grille support (see Figures A & B). Anti-tip Bracket Gasket should seal against the cabinet all the way around including top and bottom Toe Grille Support Toe Grille Cover A Toe Grille Support Toe Grille Cover IMPORTANT Should open seal condition exist, try working the gasket by hand to make sure it is seated into the channel. If the condition still exist, try heating the gasket with a hair dryer with the door closed. Be careful not to damage the interior door panel or the gasket by applying too much heat. If the open seal condition still exist, it may be necessary to flip the gasket. In this case, remove the gasket from the door by pulling it out. Rotate the gasket half a turn (180 degrees). Reinstall the gasket by inserting the corners first then work towards the middle assuring that the dart is fully seated in the channel. Anti-tip Bracket B 22. Reinstall toe grille with appropriate cover (some models). 23. Plug in electrical power cord and turn refrigerator temperature control to center position. Adjust setting as necessary. NOTE In case of future door reversals, save the toe grille cover not being used. 9