Frigidaire FFHN2740PS Use and Care Manual - Page 10

Door Removal Instructions

Page 10 highlights

DOOR REMOVAL INSTRUCTIONS  NOTE You will be pulling approximately five feet of water tube from the back of the refrigerator. 4 Unscrew the three lower hinge screws and hinge if necessary. To reinstall the right door, reverse the above steps. Lower Hinge Removal Installing Freezer Drawer 1 With lower slides pulled out, hang drawer onto slide brackets ensuring pins on each side are fully inserted into slots on each side. Drawer Assembly Fully Extend Drawer Slides Once both doors are in place, ensure they are aligned with each other and level (Please see the "Installation" section for more details), and replace the top hinge cover.  NOTE When reinserting the water tube and replacing the top hinge cover, use care to be sure you do not kink the tube. CAUTION Be sure doors are set aside in a secure position where they cannot fall and cause personal injury, or damage to the doors or handles. Removing Freezer Drawer 1 Open freezer drawer. 2 Remove drawer screws on right and left sides (two screws on each side). Remove Hex Head Drawer Screw Do Not Remove Other Screws Do Not Remove Other Screws Remove Hex Head Drawer Screw Remove Hex Head Drawer Screw Remove Hex Head Drawer Screw  NOTE Do not remove center screw from freezer drawer. This is a factory adjustment. CAUTION Drawer is heavy. Use caution when lifting. 3 Lift drawer up and out to remove. 10 Pin Slot Cabinet 2 Reinstall four drawer screws (two per side), tighten down, and close drawer (C). Install Screws (2) Each Side 3 Check gasket seal around top, bottom, and sides of freezer drawer. 4 If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each side) to allow drawer to rotate. 5 Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer. Push Against Freezer Drawer Grab Drawer At Center From Both Sides Then Pull Drawer Out A B 6 Tighten four drawer screws. 7 Recheck gasket seal. 8 Install the toe grille by fitting into place.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33

10
CAUTION
Be sure doors are set aside in a secure position where
they cannot fall and cause personal injury, or damage
to the doors or handles.
CAUTION
Drawer is heavy. Use caution when lifting.
DOOR REMOVAL INSTRUCTIONS
Once both doors are in place, ensure they are aligned
with each other and level (Please see the “Installation”
section for more details), and replace the top hinge cover.
Lower Hinge Removal
4
Unscrew the three lower hinge screws and hinge if
necessary.
To reinstall the right door, reverse the above steps.
Removing Freezer Drawer
1
Open freezer drawer.
2
Remove drawer screws on right and left sides (two
screws on each side).
3
Lift drawer up and out to remove.
Installing Freezer Drawer
1
With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are fully
inserted into slots on each side.
6
Tighten four drawer screws.
7
Recheck gasket seal.
8
Install the toe grille by fitting into place.
2
Reinstall four drawer screws (two per side), tighten
down, and close drawer (C).
Push Against
Freezer Drawer
Grab Drawer
At Center
From Both Sides
Then
Pull Drawer Out
A
B
Fully Extend
Assembly
Drawer Slides
Pin
Slot
Cabinet
Drawer
Install Screws
(2) Each Side
3
Check gasket seal around top, bottom, and sides of
freezer drawer.
4
If gasket is not sealed, open drawer and slightly
loosen four drawer screws (two on each side) to
allow drawer to rotate.
5
Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
NOTE
You will be pulling approximately five feet of water tube
from the back of the refrigerator.
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
NOTE
Do not remove center screw from freezer drawer. This
is a factory adjustment.
NOTE
When reinserting the water tube and replacing the top
hinge cover, use care to be sure you do not kink the tube.